Automate and Economize your Experience

Set and Forget Automation

For your Oasis Hydronic Heating System

AquaMatic™ Smart Controller

If your Oasis Hydronic System has a Controller that looks like this then we have what you need!

  • Fully Automatic selection between fuel source and electric element usage.

  • Electric heating priority for standby and short-term domestic hot water usage.

  • Automatic diesel/propane for cabin heat, freeze protection, and showering.

  • Economizer saves up to 60% fuel on standby without shore power (Stay).

  • Economizer saves up to 100% fuel on standby when unoccupied (Away).

 

AquaMatic™ Smart Controller

There's one more thing to know before ordering:  The Oasis controller 12-pin connector, circled in the picture below, must have a white wire and a white/black wire.  If YES you simply need Model AM3. If NO then you need Model AM4 that comes with a domestic hot water sensor.

A domestic hot water sensor kit consists of a temperature sensor that monitors your cold water inlet to your hydronic heater. Many Oasis models have this sensor installed. Some models may not. This kit places a digital temperature sensor on the water inlet as close to the boiler as possible and inside the cover of your Oasis. The sensor is put in place and affixed to the inlet tubing using high temperature silicone tape. The silicone tape both secures and insulates the sensor on the pipe or fitting.

AquaMatic™ Smart Controller

Upgrade From a Manual Transmission To An AquaMatic™